Thinking about upgrading my tool holders before December hits

[LinkWaker]

I have been staring at my setup all week thinking maybe it is finally time to upgrade my tool holders before December shows up. The shop in Indiana has been getting colder and it feels like every little vibration gets louder once the temps drop. I keep telling myself I can stretch these tool holders a bit longer but the finish on a few parts has been reminding me otherwise. Hmmm maybe the timing is not that bad since work usually slows a bit right before the holidays. Anyone else feeling the urge to tighten up their tooling this November or am I just looking for excuses to spend money again?

 

[KingGanondorf]

Every November I start hearing noises I swear weren’t there two weeks ago and suddenly I’m on a tooling website “just browsing.” Tool holders hold up well, sure, but they don’t hide bad habits in cold weather. What brand are you thinking of jumping to this time?

 

[Alan]

When the finish starts slipping a bit, that is usually a sign worth listening to even if the holders are not completely worn out. Cooler air can tighten things up in odd ways and exaggerate the chatter you were already on the edge of hearing. It could help to check runout or try a fresh collet before diving into a full upgrade just to confirm what is causing the noise. Are you seeing the vibration on certain tools only or is it showing up across most of your setups?