5 axis Haidenhain not reading code

[InfinityandBeyond]

I'm running into an issue with the 5 axis Haidenhain mill here at the shop. It's not reading the code properly, and I'm not sure where to start troubleshooting, the machine seems to be rejecting the programs, and I've double checked the code, it looks fine on my end, any ideas on what might be causing this ? I've already tried a few basic resets and reloaded the program, but no luck so far.

 

[autumnleaves]

I'm running into an issue with the 5 axis Haidenhain mill here at the shop. It's not reading the code properly, and I'm not sure where to start troubleshooting, the machine seems to be rejecting the programs, and I've double checked the code, it looks fine on my end, any ideas on what might be causing this ? I've already tried a few basic resets and reloaded the program, but no luck so far.

There's most likely a missing configuration so it's not fully set-up for 5-axis mode. Just tinker. Mostly trial and error if you're new? I suppose you're still exploring?

 

[MaiTai1]

Maybe try a different file transfer method? A corrupt file might be the problem for this

 

[darkamber]

Is the control giving any specific error messages? Those can be super helpful clues.

 

[cuts&circuits]

I'm running into an issue with the 5 axis Haidenhain mill here at the shop. It's not reading the code properly, and I'm not sure where to start troubleshooting, the machine seems to be rejecting the programs, and I've double checked the code, it looks fine on my end, any ideas on what might be causing this ? I've already tried a few basic resets and reloaded the program, but no luck so far.

Heidenhain can be particular about file format and extension, so I would check those first. Additionally, check to see if the control is rejecting the program with any particular error codes. In case it's a bad load, double-check the transfer method (USB, network, etc.). If everything appears to be in order, there may be a mismatch in the control settings. If you know the precise error, please share it, it may help focus the search

 

[Shape Of You]

Maybe try a different file transfer method? A corrupt file might be the problem for this

+1 on this. This might be the quick fix for that. Other stuff would require you for something costly or more complicated. No in between.

 

[Ginovirzosa_]

Have you tried entering the blocks manually?

 

[chamferchamp163]

Heidenhain can be particular about file format and extension

Yep, you're right, the format and how you send it matter a lot. If you don't see anything wrong right away, take a look at the settings to make sure they match. Sending the exact code helps tons.

 

[willow narcissist]

Did you check if the control has the correct options enabled for the type of code you are running? Some Heidenhain systems need specific features unlocked for certain 5 axis commands. Even if the code looks fine in your CAM output, the machine may reject it if the post processor is set for a different control version or if certain cycles or functions are not supported.